Author: Michael John
-
How to Check Motorcycle Oil Level Dipstick
To check the oil level on a motorcycle, first find the dipstick. This is usually located near the front of the engine, on the side that faces up when the bike is upright. Once you’ve found the dipstick, pull it out and wipe it off with a clean cloth. Then insert it back into the…
-
How to Fix Stripped Oil Drain Plug
The most common way to fix a stripped oil drain plug is by using a helicoil insert. This is a small metal coil that is inserted into the stripped threads of the drain plug hole. The helicoil will give the drain plug something to grip onto so it can be tightened without stripping again. What…
-
How to Reset Oil Life on Honda Civic 2018
To reset the oil life on a Honda Civic 2018, press and hold the Select/Reset button for about 10 seconds. The oil life indicator will then reset to 100%. How Do You Reset the Wrench Light on a 2018 Honda Civic? Assuming you’re referring to the Maintenance Minder Light: The Maintenance Minder Light is designed…
-
How to Apply Lucas Oil Stabilizer
To add Lucas Oil Stabilizer to your engine, first find the oil dipstick and remove it. Next, locate the oil filler cap and unscrew it. Pour in half a bottle of Lucas Oil Stabilizer, then replace the dipstick and screw on the filler cap. Start up your engine and let it idle for a few…
-
How to Use an Oil Extractor Pump
An oil extractor pump is a device that helps remove oil from an engine. The process is simple and does not require any special tools. First, the user must locate the dipstick and unscrew it. Next, they will need to place the end of the pump into the opening where the dipstick was located. Finally,…
-
How to Bypass Vtec Oil Pressure Switch
There are a few ways that you can bypass the VTEC oil pressure switch. One way is to purchase a replacement VTEC solenoid and install it in place of the old one. Another way is to disconnect the wire going to the VTEC oil pressure switch and connect it to ground. This will trick the…
-
How to Bleed Mercury Oil Tank
To bleed a mercury oil tank, locate the bleed screw on the side of the tank and open it. Place a pan under the tank to catch any oil that may drip out. Slowly turn the screw until you see oil coming out of the tank. When a steady stream of oil is flowing, close…
-
How to Read a Oil Pressure Gauge
An oil pressure gauge is a device that measures the pressure of the oil in an internal combustion engine. The pressure of the oil is an important factor in the proper operation of the engine. The oil pressure gauge is usually located on the dash panel of the vehicle. The gauge has a needle that…
-
How to Remove Oil from Cylinder
If your car’s engine is low on oil, you may need to remove some oil from the cylinder. To do this, first find the dipstick and unscrew the cap. Next, insert the dipstick into the cylinder and slowly withdraw it. Be careful not to let any oil spill out. Finally, use a clean rag to…
-
How to Stop an Oil Leak on a Motorcycle
If you have an oil leak on your motorcycle, the first thing you should do is check the oil level. If it is low, add more oil and check for leaks. If there are no leaks, the problem may be with the oil filter or seals. Check these areas for damage and replace as needed.…