Author: Michael John

Michael John Avatar
  • Should You Check Oil Hot Or Cold?

    You should check your oil when it is cold for two reasons. First, because the colder the engine is, the thicker the oil will be. This means that it won’t have drained out of all the nooks and crannies in your engine where it lubricates critical components. Second, checking your oil when it’s hot could…

    Continue reading →

  • How to Remove an Over Tightened Oil Plug?

    If your oil plug is over tightened, don’t worry. There are a few easy ways to remove it. First, try using a ratchet or wrench to loosen the plug. If that doesn’t work, you can try heating up the area around the plug with a blow dryer or heat gun. This will expand the metal…

    Continue reading →

  • How to Get a Stripped Oil Pan Bolt off?

    If you have a stripped oil pan bolt, the first thing you should do is try to remove it with a ratchet and socket. If this does not work, you can try using a drill and an extraction bit. First, drill a pilot hole into the center of the stripped bolt. Next, insert the extraction…

    Continue reading →

  • How to Change Oil Without Making a Mess?

    To change your oil without making a mess, you will need the following supplies: an oil catch pan, a ratchet and socket, an oil filter wrench, and fresh motor oil. You will also need to know where your car’s drain plug and oil filter are located. Once you have gathered your supplies, warm up your…

    Continue reading →

  • How to Get Rid of Condensation in Engine Oil?

    If your car’s engine oil has condensation in it, there are a few things you can do to get rid of the moisture. One way is to simply remove the oil fill cap and let the engine run for a few minutes. The heat from the engine will help evaporate the water. Another way is…

    Continue reading →

  • How to Dispose of Old Gas Oil Mix?

    If you have old gas oil mix that you need to dispose of, the best way to do it is to take it to a local recycling center. There, they will be able to properly dispose of the mixture and keep it from harming the environment. How Do I Get Rid of Gas And Oil…

    Continue reading →

  • How to Use Ramps to Change Oil?

    If you don’t have a garage and need to change your oil, ramps are a great option. You can find them at any auto store and they’re relatively inexpensive. Just drive your car up the ramp, set the parking brake, and put a jack under the frame. Then you can remove the drain plug and…

    Continue reading →

  • How to Test Oil Viscosity at Home?

    There are a few ways that you can test the viscosity of your oil at home. One way is to use a cup and timer. Fill the cup with oil and start the timer. At the end of one minute, check to see how far the oil has risen up the sides of the cup.…

    Continue reading →

  • How to Replace an Oil Pump in a Chevy Silverado?

    Replacing an oil pump in a Chevy Silverado is not difficult, but it does require some basic mechanical skills. To do the job, you’ll need a few tools, including a socket set and a wrench set. You’ll also need an oil pan to catch the old oil. Start by disconnecting the battery and then draining…

    Continue reading →

  • How to Open Castrol Oil Bottle?

    To open a Castrol oil bottle, unscrew the cap and pour the desired amount of oil into your vehicle. If the bottle has a pour spout, insert the spout into the opening and release the oil. How Do You Open an Oil Bottle Cap? Assuming you are referring to a standard cooking oil bottle: To…

    Continue reading →