Author: Michael John

Michael John Avatar
  • How to Remove Moisture from Engine Oil?

    Assuming you would like tips on how to remove moisture from engine oil: Condensation can form in your car’s engine oil when the temperature changes, causing the water to separate from the oil. This water-contaminated oil can cause corrosion and sludge build-up, which can damage your engine. There are a few ways you can remove…

    Continue reading →

  • How to Spray Motor Oil?

    To spray motor oil, first make sure that the area is well ventilated. Next, put on gloves and a face mask to protect yourself from fumes. Then, pour the motor oil into a container with a nozzle attachment. Finally, point the nozzle towards the surface you wish to lubricate and squeeze the trigger to release…

    Continue reading →

  • How to Change Oil on Honda Gcv160 Lawn Mower?

    To change the oil on a Honda GCV160 lawn mower, you will need: -5W-30 motor oil -A Phillips head screwdriver -An oil drain pan -A funnel (optional) 1. Park your lawn mower on a level surface and turn it off. Remove the key from the ignition to prevent accidental starting. 2. Use the Phillips head…

    Continue reading →

  • How to Get Oil Out of 5 Gallon Bucket?

    The easiest way to get oil out of a 5 gallon bucket is with a pump. You can purchase a hand operated pump at most hardware stores. Simply insert the pump into the opening at the top of the bucket and start pumping. The oil will flow out of the bucket and into whatever container…

    Continue reading →

  • How to Change Oil in a Honda Gcv160 Lawn Mower?

    To change the oil in your Honda GCV160 lawn mower, first find the oil fill cap on the side of the engine. Remove the cap and then use a funnel to pour in new oil until it reaches the full line. Next, remove the oil drain plug at the bottom of the engine and let…

    Continue reading →

  • How to Check Oil in Harley Davidson Ultra Classic?

    To check the oil in your Harley Davidson Ultra Classic, first make sure that the bike is on level ground. Then, remove the dipstick from the oil tank and wipe it off with a clean cloth. Reinsert the dipstick into the tank and then pull it out again to check the oil level. The oil…

    Continue reading →

  • How to Stop Oil Coming Out of Valve Cover Breather?

    If your valve cover has a breather, it is there to allow the engine to “breath.” As the engine heats up and cools down, the oil in the crankcase expands and contracts. This can cause pressure to build up in the crankcase, and the breather allows that pressure to be released. If you see oil…

    Continue reading →

  • How to Change Oil Mazda 6?

    If you’re unsure about how to change the oil in your Mazda 6, here’s a quick guide. You’ll need some supplies before you get started: an oil filter, a drain pan, and fresh motor oil. To change the oil, first locate the oil drain plug and unscrew it with a wrench. Place the drain pan…

    Continue reading →

  • How to Reset Oil Life on 2006 Honda Civic?

    To reset the oil life on a 2006 Honda Civic, press and hold the Select/Reset button for about 10 seconds. The oil life will then be reset to 100%. How Do You Reset the Oil Life on a Honda Civic? If you need to reset the oil life monitor on your Honda Civic, follow these…

    Continue reading →

  • How to Prime Oil Pump Ford 302?

    To prime the oil pump on a Ford 302 engine, first make sure that the oil pan is full of oil. Then, remove the oil cap and turn the engine over slowly by hand until you see oil pressure on the gauge. Next, start the engine and let it run for a few minutes before…

    Continue reading →