Assuming you would like tips on changing the oil in a Subaru Impreza: -Locate the oil drain plug and oil filter on the underside of the car. The oil drain plug will be close to the center of the car, while the oil filter is usually off to one side. -Place an oil catch pan…
Carefully remove the lamp from its location, taking care not to spill any oil. Place the lamp on a level surface and unscrew the filler cap. Check to see if the wick is too low and needs to be trimmed. If so, use a sharp knife or scissors to trim it down to about 1/4…
To reset the oil light on a 2011 Toyota Camry, first make sure that the car is parked on level ground and turn off the engine. Next, locate the oil dipstick and remove it. Wipe off any oil that is on the dipstick and reinsert it into the car. Finally, start up the engine and…
If you don’t have access to ramps, you can still change your oil without them. Park your car on a level surface and engage the parking brake. Place an oil catch pan underneath the drain plug on the bottom of the engine. Loosen the drain plug with a wrench and allow all of the old…
The oil pump in a 5.4 Triton engine is located at the bottom of the oil pan. To change it, first remove the oil pan and then the oil pump. The new oil pump can be installed by reversing these steps. Can You Change an Oil Pump Yourself? If you’re a car owner, it’s important…
To reset the oil light on a Ford F150, first make sure that the vehicle is turned off. Next, open the hood and locate the oil dipstick. With the engine cool, remove the dipstick and wipe it clean with a rag. Reinsert the dipstick all the way back into its tube, then remove it again…
If you own a Prius, chances are you want to save money on gas. One way to do that is to change the oil regularly. Here’s how: 1. Park your car on a level surface and set the parking brake. 2. Place a container under the drain plug to catch the old oil. 3. Remove…
To add oil to your car without a funnel, first remove the dipstick and wipe it clean. Next, slowly pour the oil into the opening where the dipstick was. Be careful not to overfill! Once you’re finished, insert the dipstick and screw on the cap. What Can I Use Instead of a Funnel for Oil?…
To remove oil from an intake manifold, first identify the source of the leak and repair it. Next, use a degreaser to break down the oil, then flush the area with hot water. Finally, use a vacuum cleaner to remove any remaining oil. What is the Best Way to Clean an Intake Manifold? Assuming you…
Removing a stripped oil pan bolt can be a difficult and frustrating task. There are a few different methods that you can try in order to remove the bolt, but it may take some trial and error to find the one that works best for your situation. One method is to use a drill bit…