Author: Michael John

Michael John Avatar
  • How to Reset Oil Life on Honda Civic 2018

    To reset the oil life on a Honda Civic 2018, press and hold the Select/Reset button for about 10 seconds. The oil life indicator will then reset to 100%. How Do You Reset the Wrench Light on a 2018 Honda Civic? Assuming you’re referring to the Maintenance Minder Light: The Maintenance Minder Light is designed…

    Continue reading →

  • How to Apply Lucas Oil Stabilizer

    To add Lucas Oil Stabilizer to your engine, first find the oil dipstick and remove it. Next, locate the oil filler cap and unscrew it. Pour in half a bottle of Lucas Oil Stabilizer, then replace the dipstick and screw on the filler cap. Start up your engine and let it idle for a few…

    Continue reading →

  • How to Use an Oil Extractor Pump

    An oil extractor pump is a device that helps remove oil from an engine. The process is simple and does not require any special tools. First, the user must locate the dipstick and unscrew it. Next, they will need to place the end of the pump into the opening where the dipstick was located. Finally,…

    Continue reading →

  • How to Bypass Vtec Oil Pressure Switch

    There are a few ways that you can bypass the VTEC oil pressure switch. One way is to purchase a replacement VTEC solenoid and install it in place of the old one. Another way is to disconnect the wire going to the VTEC oil pressure switch and connect it to ground. This will trick the…

    Continue reading →

  • How to Bleed Mercury Oil Tank

    To bleed a mercury oil tank, locate the bleed screw on the side of the tank and open it. Place a pan under the tank to catch any oil that may drip out. Slowly turn the screw until you see oil coming out of the tank. When a steady stream of oil is flowing, close…

    Continue reading →

  • How to Read a Oil Pressure Gauge

    An oil pressure gauge is a device that measures the pressure of the oil in an internal combustion engine. The pressure of the oil is an important factor in the proper operation of the engine. The oil pressure gauge is usually located on the dash panel of the vehicle. The gauge has a needle that…

    Continue reading →

  • How to Remove Oil from Cylinder

    If your car’s engine is low on oil, you may need to remove some oil from the cylinder. To do this, first find the dipstick and unscrew the cap. Next, insert the dipstick into the cylinder and slowly withdraw it. Be careful not to let any oil spill out. Finally, use a clean rag to…

    Continue reading →

  • How to Stop an Oil Leak on a Motorcycle

    If you have an oil leak on your motorcycle, the first thing you should do is check the oil level. If it is low, add more oil and check for leaks. If there are no leaks, the problem may be with the oil filter or seals. Check these areas for damage and replace as needed.…

    Continue reading →

  • How to Change Oil Filter Without Tool

    If your car has an oil filter that can be accessed from the top of the engine, you can change it without any tools. Simply remove the old filter and screw on the new one. If your car’s oil filter is located underneath the engine, you will need a wrench to remove it. Once the…

    Continue reading →

  • How to Reset Oil Light Honda Civic 2017

    To reset the oil light on a Honda Civic 2017, locate the oil dipstick and unscrew the cap. Wipe the dipstick clean with a rag and reinsert it into the engine. Turn the ignition key to the “On” position without starting the engine and wait for three seconds. Remove the key and check that the…

    Continue reading →