Author: Michael John
-
How to Install a Crush Washer on Oil Drain Plug?
If your car has an oil drain plug that uses a crush washer, you’ll need to replace the washer whenever you change your oil. Here’s how to do it: 1. Remove the old washer from the drain plug. 2. Place the new washer on the drain plug and screw it in by hand until it’s…
-
How to Check Outdrive Oil Level?
First, locate the oil dipstick on the outdrive. Next, remove the dipstick and wipe it clean with a rag. reinsert the dipstick all the way back in, then pull it out again to check the oil level. The oil should be at or above the “full” line on the dipstick. If it’s not, add more…
-
How to Use Fogging Oil?
To use fogging oil, pour a small amount into the cylinder of your outboard motor or other gas-powered engine. Then, start the engine and let it run for a few minutes. Next, shut off the engine and allow it to cool completely. Finally, drain the oil from the cylinder and dispose of it properly. How…
-
How to Fix Hole in Oil Pan?
If your oil pan has a hole in it, you’ll need to replace it. You can buy a new oil pan at your local auto parts store, or online. To replace the oil pan, first remove the old one. Then clean the area around the hole with a wire brush and sandpaper. Next, apply a…
-
How to Check Primary Oil on Harley Davidson?
If you want to check the primary oil on your Harley Davidson, there are a few things that you need to do. First, find the dipstick on your engine and remove it. Then, wipe the dipstick off with a clean rag and reinsert it into the engine. Next, pull the dipstick out again and check…
-
How to Get Oil Out of Spark Plug Well?
To remove oil from a spark plug well, use a clean rag or paper towel to soak up the oil. Then, use a wire brush or other tool to scrub the area where the oil was found. If possible, flush the area with brake cleaner or another solvent. Will Oil in Spark Plug Well Burn…
-
How to Make a Oil Catch Can?
A catch can is used in order to collect oil and other fluids that may be released during engine operation. In order to make a catch can, you will need a few supplies including: a container, hose, clamps, fittings, and grease. You will also need to drill a few holes in the container in order…
-
How to Get Oil off Windshield?
To remove oil from your windshield, you will need: 1. A clean, dry cloth 2. Glass cleaner 3. Vinegar 4. Baking soda 5. A squeegee (optional) Instructions: 1. Wipe the oil spot with a clean, dry cloth to remove as much excess oil as possible. 2. Spray the area with glass cleaner and wipe it…
-
How to Unstick Oil Rings?
If your oil rings are sticking, there are a few things you can do to try and unstick them. One is to use a steel pick or other sharp object to clean out the carbon buildup around the rings. Another is to heat up the engine with a torch and then try to push the…
-
How to Tell If Oil Has Friction Modifiers?
If you are trying to determine if oil has friction modifiers, there are a few tests you can perform. One test is to add a small amount of the oil to a container of water and see if it forms beads or if it mixes evenly with the water. Another test is to put a…