Author: Michael John
-
How to Change Oil in a Honda Gcv160 Lawn Mower?
To change the oil in your Honda GCV160 lawn mower, first find the oil fill cap on the side of the engine. Remove the cap and then use a funnel to pour in new oil until it reaches the full line. Next, remove the oil drain plug at the bottom of the engine and let…
-
How to Check Oil in Harley Davidson Ultra Classic?
To check the oil in your Harley Davidson Ultra Classic, first make sure that the bike is on level ground. Then, remove the dipstick from the oil tank and wipe it off with a clean cloth. Reinsert the dipstick into the tank and then pull it out again to check the oil level. The oil…
-
How to Stop Oil Coming Out of Valve Cover Breather?
If your valve cover has a breather, it is there to allow the engine to “breath.” As the engine heats up and cools down, the oil in the crankcase expands and contracts. This can cause pressure to build up in the crankcase, and the breather allows that pressure to be released. If you see oil…
-
How to Change Oil Mazda 6?
If you’re unsure about how to change the oil in your Mazda 6, here’s a quick guide. You’ll need some supplies before you get started: an oil filter, a drain pan, and fresh motor oil. To change the oil, first locate the oil drain plug and unscrew it with a wrench. Place the drain pan…
-
How to Reset Oil Life on 2006 Honda Civic?
To reset the oil life on a 2006 Honda Civic, press and hold the Select/Reset button for about 10 seconds. The oil life will then be reset to 100%. How Do You Reset the Oil Life on a Honda Civic? If you need to reset the oil life monitor on your Honda Civic, follow these…
-
How to Prime Oil Pump Ford 302?
To prime the oil pump on a Ford 302 engine, first make sure that the oil pan is full of oil. Then, remove the oil cap and turn the engine over slowly by hand until you see oil pressure on the gauge. Next, start the engine and let it run for a few minutes before…
-
How to Change Oil Subaru Impreza?
Assuming you would like tips on changing the oil in a Subaru Impreza: -Locate the oil drain plug and oil filter on the underside of the car. The oil drain plug will be close to the center of the car, while the oil filter is usually off to one side. -Place an oil catch pan…
-
How to Fix a Leaking Oil Lamp?
Carefully remove the lamp from its location, taking care not to spill any oil. Place the lamp on a level surface and unscrew the filler cap. Check to see if the wick is too low and needs to be trimmed. If so, use a sharp knife or scissors to trim it down to about 1/4…
-
How to Reset Oil Light on 2011 Toyota Camry?
To reset the oil light on a 2011 Toyota Camry, first make sure that the car is parked on level ground and turn off the engine. Next, locate the oil dipstick and remove it. Wipe off any oil that is on the dipstick and reinsert it into the car. Finally, start up the engine and…
-
How to Change Oil Without Ramps?
If you don’t have access to ramps, you can still change your oil without them. Park your car on a level surface and engage the parking brake. Place an oil catch pan underneath the drain plug on the bottom of the engine. Loosen the drain plug with a wrench and allow all of the old…