Author: Michael John
-
How to Bypass Vtec Oil Pressure Switch
There are a few ways that you can bypass the VTEC oil pressure switch. One way is to purchase a replacement VTEC solenoid and install it in place of the old one. Another way is to disconnect the wire going to the VTEC oil pressure switch and connect it to the ground. This will trick…
-
How to Bleed Mercury Oil Tank
.To bleed a mercury oil tank, locate the bleed screw on the side of the tank and open it. Place a pan under the tank to catch any oil that may drip out. Slowly turn the screw until you see oil coming out of the tank. When a steady stream of oil is flowing, close…
-
How to Read a Oil Pressure Gauge
An oil pressure gauge is a device that measures the pressure of the oil in an internal combustion engine. The pressure of the oil is an important factor in the proper operation of the engine. The oil pressure gauge is usually located on the dashboard of the vehicle. The gauge has a needle that indicates…
-
How to Remove Oil from Cylinder
If your car’s engine is low on oil, you may need to remove some oil from the cylinder. To do this, first, find the dipstick and unscrew the cap. Next, insert the dipstick into the cylinder and slowly withdraw it. Be careful not to let any oil spill out. Finally, use a clean rag to…
-
How to Stop an Oil Leak on a Motorcycle
If you have an oil leak on your motorcycle, the first thing you should do is check the oil level. If it is low, add more oil and check for leaks. If there are no leaks, the problem may be with the oil filter or seals. Check these areas for damage and replace them as…
-
How to Change Oil Filter Without Tool
If your car has an oil filter that can be accessed from the top of the engine, you can change it without any tools. Simply remove the old filter and screw on the new one. If your car’s oil filter is located underneath the engine, you will need a wrench to remove it. Once the…
-
How to Reset Oil Light Honda Civic 2017
To reset the oil light on a Honda Civic 2017, locate the oil dipstick and unscrew the cap. Wipe the dipstick clean with a rag and reinsert it into the engine. Turn the ignition key to the “On” position without starting the engine and wait for three seconds. Remove the key and check that the…
-
How to Convert to Synthetic Oil
Before you convert to synthetic oil, consult your car’s owner’s manual. You may find that synthetic oil is not recommended for your car. If it is, follow these steps: 1. Find out how much oil your car holds and purchase the same synthetic oil. 2. Park your car on level ground and wait until the…
-
How to Fix Milky Oil in Engine
To fix the milky oil in your engine, you will need to flush the system and replace the oil. Begin by draining all of the oil from the engine using a catch pan. Next, remove the oil filter and discard it. Using a clean cloth, wipe out any remaining oil inside the housing. Now, fill…
-
How to Remove a Stuck Oil Cap
The oil cap on your car is there to keep the oil in and the dirt and water out. Over time, the cap can become stuck due to built-up residue. If you find yourself unable to remove the oil cap, don’t worry. With a little patience and some household supplies, you can get it off.…