Author: Michael John
-
How to Tell If There’S Water in Your Oil?
If you’re unsure whether there’s water in your oil, there are a few things you can do to check. One way is to simply look at the oil; if it’s cloudy or milky, that’s a sign that water is present. Another way is to feel the oil; if it feels slippery or greasy, that could…
-
How to Fix a Stripped Out Oil Drain Plug?
If you have a stripped out oil drain plug, you will need to replace it with a new one. You can buy a replacement oil drain plug at your local auto parts store. To install the new oil drain plug, first remove the old one. Then, clean the area around the oil drain hole with…
-
How to Replace Oil Sending Unit?
To replace an oil sending unit, first remove the old unit by unscrewing it from the engine block. Next, clean the mounting surface on the engine block and install the new unit. Screw the new unit into place and reconnect any wires or hoses that were attached to the old unit. Finally, start the engine…
-
How to Reset Oil Life on 2012 Dodge Ram?
The oil life on a 2012 Dodge Ram can be reset by performing the following steps: 1. Turn the ignition key to the “On” position, but do not start the engine. 2. Press and release the gas pedal three times within five seconds. 3. Turn off the ignition key. How Do You Reset the Oil…
-
How to Convert Diesel Truck to Vegetable Oil?
There are a few different ways that you can convert your diesel truck to run on vegetable oil. One way is to install a Vegetable Oil Conversion Kit, which will allow you to run your truck on either diesel fuel or vegetable oil. Another way is to build your own conversion system using an Vegematic…
-
How to Change Oil on Goldwing 1800?
To change the oil on your Goldwing 1800, you will need: four quarts of 10W40 motorcycle oil, a metric socket set, an oil filter wrench, and a drain pan. 1) Park your bike on a level surface and warm up the engine for about five minutes to help loosen the old oil. 2) Place the…
-
How to Reset Oil Maintenance Light on 2010 Prius?
To reset the oil maintenance light on a 2010 Prius, first turn the ignition to the “On” position without starting the engine. Then press and release the power button on the steering wheel. Next, depress and release the brake pedal three times. Finally, start the engine to complete the reset process. How Do You Reset…
-
How to Oil Bcg?
1. Place the BCG on a surface with the gas key facing up. 2. Apply a few drops of oil to the gas key and spread it around with your finger. 3. Flip the BCG over and apply a few drops of oil to the bolt carrier itself, again spreading it around with your finger.…
-
How to Remove Oil Smell from Garage?
Assuming the oil smell is coming from an oil spill, you can remove it by cleaning up the spill with a paper towel or cloth. If the smell persists, you can try using a vinegar and water solution to clean the area. You can also try leaving out bowls of baking soda to absorb the…
-
How to Change Pump Oil in Dewalt Pressure Washer?
To change the oil in a Dewalt pressure washer, first shut off the engine and disconnect the spark plug wire. Next, drain the old oil by removing the oil drain plug and draining the oil into a container. Then, remove the oil filter and replace it with a new one. Finally, fill the pressure washer…