Author: Michael John

Mink oil is a popular leather conditioner that can darken and soften the leather. However, it can also make the leather feel greasy and attract dirt. If you want to remove mink oil from your leather, you can do so by using a clean cloth to wipe away any excess oil. You can then use…

Continue reading →

The oil cap is located on the top of the engine, usually on the right side. To open it, simply turn it counterclockwise. If it is too tight, you may need to use a wrench. Be careful not to over tighten it when you close it. Why Can’T I Open My Oil Cap? If you’re…

Continue reading →

The 2017 Honda Civic has an oil life sensor that will monitor the engine oil quality and notify you when it’s time for a change. You can reset the oil light by following these steps: 1. Turn the ignition switch to ON (II). 2. Press and hold the Select/Reset knob for more than 5 seconds.…

Continue reading →

To reset the oil life on a 2017 Honda Civic, press and hold the Select/Reset button for about 10 seconds. The oil life indicator will then display 100%. How Do You Check the Oil Life on a 2017 Honda Civic? Assuming you would like a blog post about how to check the oil life on…

Continue reading →

To reset the Camaro oil light, simply turn the key to the “On” position without starting the engine. Then depress and release the gas pedal three times within five seconds. Finally, start the engine and allow it to idle for one minute before driving. How Do You Reset the Oil Life on a Camaro? Assuming…

Continue reading →

If you own a Polaris Sportsman 500, chances are you perform your own maintenance. Part of that maintenance is changing the oil. Here is a step-by-step guide on how to change the oil in your Polaris Sportsman 500. 1. Park your ATV on a level surface and turn off the engine. Place a drain pan…

Continue reading →

If you have a Yamaha outboard 4 stroke, then you will need to know how to change the oil. The process is actually quite simple and does not take very long. Here are the steps that you need to follow: 1) Locate the oil drain plug on the bottom of the engine. This is usually…

Continue reading →

To change the lower unit oil on your outboard, you will need to start by draining the old oil. To do this, locate the drain plug on the lower unit and remove it. Then, allow all of the old oil to drain out into a catch pan. Once the oil has finished draining, replace the…

Continue reading →

To test your oil pressure gauge, you will need a few tools. A digital multimeter is the best tool to use, but you can also use an analog multimeter. You will also need a small screwdriver and a cloth. First, locate the oil pressure sending unit on your vehicle. It is usually located near the…

Continue reading →

If your car has an oil cooler, you will need to install it before you can start using the car. Here is a step by step guide on how to install an oil cooler: 1. Find the location of the oil filter and unscrew it. 2. Remove the old oil cooler from its location. 3.…

Continue reading →