Category: Blog
-
How to Check an Oil Pump?
To check an oil pump, first make sure that the engine is cool and then remove the oil dipstick. Next, locate the oil pressure sending unit on the side of the engine block and unscrew it. After that, attach a mechanical gauge to the sending unit port and start the engine. Finally, check the reading…
-
How to Get Fresh Oil off Your Car?
To remove fresh oil from your car, you will need: -A clean cloth or paper towels -A jar of warm water -Dish soap -A second clean cloth or paper towels 1. Soak the first cloth or paper towel in the warm water. 2. Add a few drops of dish soap to the wet cloth or…
-
How to Check Oil in Prius?
There are two ways to check the oil in your Prius. The first is to use the dipstick. The second is to check the oil level indicator on the multi-information display. How Do I Know If My Prius Is Low on Oil? If you own a Prius, it’s essential to know how to check your…
-
How to Clean Old Oil off Concrete?
To remove old oil stains from concrete, first mix a solution of 1 part dish soap to 3 parts warm water. Next, use a stiff brush to scrub the stain vigorously. If the stain is still visible, you can try using a pressure washer with detergent to remove it. Does Dawn Dish Soap Remove Oil…
-
How to Oil Hedge Trimmer?
An oil hedge trimmer is a tool that is used to trim hedges and shrubs. The oil hedge trimmer features a long, sharp blade attached to a handle. The user holds the handle in one hand and uses the other hand to guide the blade along the desired path. Can I Use WD-40 to Lubricate…
-
How to Remove Oil Stains from Backpacks?
If you have an oil stain on your backpack, you can remove it by using a small amount of dish soap and warm water. First, wet the area with a mixture of dish soap and water, and then scrub it gently with a soft brush. Rinse the area thoroughly with warm water, then let it…
-
How to Loose Oil Drain Plug?
The oil drain plug is typically located on the bottom of the engine, near the oil pan. In order to remove it, you will need a wrench that fits the size of the plug. Once you have located the plug, place the wrench on it and turn it counterclockwise until it is loose enough to…
-
How to Use Seafoam in Oil?
Seafoam is an engine treatment that can be added to your oil or gas tank to clean and lubricate your engine. It is safe for all engines, including those with catalytic converters. To use seafoam in your oil, simply add it to your oil at the next oil change. For best results, add seafoam when…
-
How to Install Oil Catch Can?
An oil catch can is a device used to separate oil and other contaminants from the air being expelled by an internal combustion engine. The catch can trap these contaminants before they can enter the engine’s intake system, where they could cause damage. Installing an oil catch can is a relatively simple process that can…
-
How to Check Oil on Yamaha Grizzly 660?
Before checking the oil, the Yamaha Grizzly 660 should be turned off and given time to cool down. Once it is cooled, locate the dipstick on the left side of the engine near the front. The dipstick will have two marks that indicate the full and low levels of oil. Pull out the dipstick and…