Category: Blog
-
How to Drain Oil?
Assuming you would like tips on how to drain your car’s oil, follow these steps: 1. Park your car on a level surface and wait until the engine is cool before proceeding. 2. Find the oil drain plug underneath your car. It is typically located near the middle or back of the vehicle, close to…
-
How to Prime an Engine With Oil?
If your engine is starting to sound a bit ‘off,’ it might be time for an oil change. But before you do that, you need to prime the engine with oil. This will ensure that all the moving parts in your engine are properly lubricated and won’t cause damage when they’re in operation. Here’s how…
-
How to Know Oil Pump is Bad?
If your vehicle has an oil pump, it is essential to know how to identify if it is malfunctioning. Several signs may indicate your oil pump is malfunctioning. The first sign is if your vehicle starts making a loud noise when you turn it on. This noise will usually be coming from the engine area.…
-
How to Stop Oil from Foaming?
If your oil is foaming, it’s likely because it’s old or has been exposed to water. To stop the foaming, try adding a drop or two of dish soap to the oil first. If that doesn’t work, you can try heating the oil until the bubbles disappear. What Causes Oil to Foam Have you ever…
-
How to Change Harley Oil?
To change Harley oil, you will need: a new filter, fresh oil, a drain pan, and an adjustable wrench. First, remove the old filter and discard it. Next, use the wrench to loosen the drain plug at the bottom of the engine. Allow all of the oil to drain into the pan. Once finished draining,…
-
How to Remove Excess Oil from Car Ac System?
There are several steps you can take to remove excess oil from your car’s air conditioning (AC) system. One is to let the system run for a while and allow the oil to evaporate. Another is to use a vacuum pump to suck out the oil. Finally, you can flush the system with a solvent,…
-
How to Install a Crush Washer on Oil Drain Plug?
If your car has an oil drain plug that uses a crush washer, you’ll need to replace the washer whenever you change your oil. Here’s how to do it: 1. Remove the old washer from the drain plug. 2. Place the new washer on the drain plug and screw it in by hand until it’s…
-
How to Check Outdrive Oil Level?
First, locate the oil dipstick on the outdrive. Next, remove the dipstick and wipe it clean with a rag. Reinsert the dipstick, then pull it out again to check the oil level. The oil should be at or above the “full” line on the dipstick. If it’s not, add more oil until it reaches that…
-
How to Use Fogging Oil?
To use fogging oil, pour a small amount into the cylinder of your outboard motor or other gas-powered engine. Then, start the engine and let it run for a few minutes. Next, shut off the engine and allow it to cool completely. Finally, drain the oil from the cylinder and dispose of it properly. How…
-
How to Fix Hole in Oil Pan?
If your oil pan has a hole in it, you’ll need to replace it. You can buy a new oil pan at your local auto parts store or online. To replace the oil pan, first remove the old one. Then clean the area around the hole with a wire brush and sandpaper. Next, apply a…