Blog

If your engine oil is overfilled, you will need to remove some of the oil. The easiest way to do this is to use a hand pump or syringe to remove the excess oil. You can also siphon out the oil, but this can be messy and difficult. Once you have removed the excess oil,…

The oil level in your car can be checked without using the dipstick by following these steps: 1. Park your car on a level surface and turn off the engine. 2. Locate the oil fill cap on the top of the engine. 3. Remove the oil fill cap and wipe any dirt or debris from…

Assuming you would like tips on how to clean oil off an engine: 1. Start with a cool engine- never clean a hot engine as it can cause injury. 2. Use a degreaser or soap and water to remove any surface grime or dirt. Be sure not to use a pressure washer, as the high-pressure…

If your boat has an oil leak, you will need to pump the oil out of the engine. You will need a few tools to do this, including a siphon pump, a catch basin, and some rags. First, locate the source of the leak. If it is coming from the engine itself, you will need…

A transmission oil cooler helps to keep the transmission fluid cool, which in turn keeps the transmission from overheating. There are two main types of transmission oil coolers: air-cooled and liquid-cooled. Air-cooled transmission oil coolers are typically less expensive than liquid-cooled ones, but they are not as effective at cooling the fluid. Liquid-cooled transmission oil…

Before checking the oil level, the car should be turned off and given a few minutes to cool so that the oil has had time to settle. The dipstick is usually located near the front of the engine on the side and has a yellow or orange loop at one end. To check the oil,…

Most boat engines will have different oil change requirements, so it is important to consult your engine’s owner’s manual. However, as a general rule of thumb, outboard gear oil should be changed every 50 hours or once a season, whichever comes first. Assuming you have an outboard motor, here are some tips on how often…

If you have a stripped bolt on your oil pan, there are a few ways to remove it. You can use a drill bit and drill out the center of the bolt. Alternatively, you can use an impact driver to loosen the bolt. If the bolt is still stuck, you may need to use a…

To unclip an oil pressure sensor, first locate the sensor on the engine. Once found, use a pair of pliers to disconnect the electrical connector from the sensor. Finally, use a wrench to loosen and remove the sensor from its mounting location. How Do You Disconnect a Low Oil Sensor? If your car is equipped…

If you have a stripped oil drain bolt, you will need to remove it before you can change your oil. There are a few ways that you can do this. One way is to use a drill and a small drill bit to create a new hole in the center of the stripped bolt. Then,…

To twin two oil tanks together, you will need to follow these steps: 1. Clean the surface of the two tanks that will be touching. This will ensure a good seal. 2. Place one tank on top of the other, lining up the holes that will need to be connected. 3. Use a welder to…

The oil life indicator on a 2017 Honda Civic lets the driver know when it’s time to change the engine oil. The indicator is reset by pressing and holding the Select/Reset button on the instrument panel for about 10 seconds with the ignition key in the ON position. How Do You Check the Oil Life…

A BMW should have its oil changed every 7,500 miles or once a year, whichever comes first. How often should a BMW get an oil change? BMW recommends that you change your oil every 7,500 miles or once a year, whichever comes first. However, if you drive your BMW in stop-and-go traffic or extreme weather…

If an oil pump is bad, it will not be able to properly lubricate the engine. This can cause the engine to overheat and seize up. To tell if an oil pump is bad, look for signs of leaking oil, low oil pressure, or noise coming from the pump. How Do You Check an Oil…