Category: Blog
-
How to Install Oil Catch Can?
An oil catch can is a device used to separate oil and other contaminants from the air being expelled by an internal combustion engine. The catch can trap these contaminants before they can enter the engine’s intake system, where they could cause damage. Installing an oil catch can is a relatively simple process that can…
-
How to Check Oil on Yamaha Grizzly 660?
Before checking the oil, the Yamaha Grizzly 660 should be turned off and given time to cool down. Once it is cooled, locate the dipstick on the left side of the engine near the front. The dipstick will have two marks that indicate the full and low levels of oil. Pull out the dipstick and…
-
How to Read Oil Dipstick With 2 Holes
To read your oil dipstick, remove it from the engine and wipe any oil off of it with a clean rag. Then, reinsert the dipstick into the engine and pull it out again. Look at the end of the dipstick that you just inserted into the engine—this is the “full” mark. Now, look at the…
-
How to Drain a Quart of Oil?
You will need a few tools to complete this task, including a wrench, pliers, and a catch pan. Loosen the oil drain plug with the wrench, ensuring it is secure before continuing. Place the catch pan underneath the oil pan and use the pliers to remove the oil filter. Be careful when removing the filter,…
-
How to Remove Antifreeze from Engine Oil?
To remove antifreeze from engine oil, use a siphon pump to remove the oil from the engine. Next, drain the antifreeze from the radiator and add fresh coolant. Finally, change the engine oil and filter. Will Antifreeze in Oil Damage the Engine? Yes, antifreeze in oil can damage the engine. Antifreeze is designed to lower…
-
How to Change Oil in Yamaha 115 4 Stroke Outboard?
1. Place the outboard on a flat surface, such as an oil change pad or a drop cloth. If you don’t have either of these, you can place the outboard on its side on a level surface. 2. Remove the oil cap and dipstick from the outboard. Wipe the dipstick clean with a rag and…
-
How to Change Fork Oil on Harley Softail?
To change the fork oil on a Harley Softail, first remove the front wheel. Next, remove the fork caps and drain the old oil. Then, add new fork oil and replace the fork caps. Finally, reinstall the front wheel. How Often Should Harley Fork Oil Be Changed? Harley-Davidson recommends changing the fork oil every 25,000…
-
How to Clean Burnt Oil?
If you have burnt oil on your cookware, don’t worry! It is easy to clean. First, fill the sink with hot, soapy water. Then, using a scrubby sponge or steel wool, scrub the affected area until the burnt oil comes off. If necessary, use a little bit of elbow grease! Finally, rinse the cookware well…
-
How to Drain Transmission Oil?
The process of draining transmission oil is relatively straightforward and can be performed at home with a few basic tools. First, locate the drain plug on the bottom of the transmission pan and place a drain pan underneath. Then, using a wrench, loosen the drain plug and allow the oil to drain out completely. Once…
-
How to Fix Stripped Oil Drain Plug on Atv?
If the oil drain plug on your ATV is stripped, you will need to replace it. To do this, first remove the old plug by unscrewing it with a wrench. Then, clean the area around the drain hole with a rag to remove any dirt or debris. Next, take a new oil drain plug and…