Category: Blog

  • How to Test for Coolant in Oil?

    If you want to test for coolant in oil, the best way to do it is to take a sample of your oil and put it into a clear container. Then, add an equal amount of water to the container and shake it up. If you see any bubbles or foam forming on the surface…

    Continue reading →

  • How to Dispose of Oil Filters Correctly?

    Oil filters can be recycled at most auto parts stores. The used oil and filter must be drained completely before recycling. Once the oil has been drained, the filter can be removed and placed in the recycling bin. How Do I Dispose of an Oil Filter That Has Been Drained? Assuming you have already drained…

    Continue reading →

  • How to Drain Oil from Honda Lawn Mower?

    To drain the oil from your Honda lawn mower, first locate the oil fill cap and dipstick. Remove the cap/dipstick and wipe it clean with a rag. Next, place an oil catch pan underneath the mower’s engine. Locate the oil drain plug on the bottom of the engine and remove it using a wrench. Allow…

    Continue reading →

  • How to Oil a Condenser Fan Motor?

    Instructions for oiling a condenser fan motor: 1. Unplug the power cord from the outlet and remove any fasteners holding the housing in place. 2. Remove the housing to access the fan blades and motor. 3. Locate the oil ports on the side of the motor (there may be more than one). 4. Insert an…

    Continue reading →

  • How to Remove Oil And Transmission Fluid from Concrete?

    There are a few ways to remove oil and transmission fluid from concrete. One way is to use a product like Oil-Dri that will absorb the fluids. Another way is to use a pressure washer with detergent to break down and remove the fluids. What is the Fastest Way to Get Oil Out of Concrete?…

    Continue reading →

  • How to Oil a Red Ryder Bb Gun?

    To oil your Red Ryder BB gun, first make sure it is unloaded. Then, using a drop of oil on the end of a clean rag, wipe down the length of the barrel. Next, apply a drop of oil to each pivot point on the gun, such as where the barrel meets the receiver and…

    Continue reading →

  • How to Remove a Rounded Oil Drain Plug?

    If your oil drain plug is rounded, you will need to replace it. You can remove a rounded oil drain plug by using a pair of pliers. First, remove the old oil drain plug by unscrewing it with the pliers. Next, take the new oil drain plug and screw it into place. Finally, tighten the…

    Continue reading →

  • How to Remove Oil Film from Windshield?

    To remove an oil film from your windshield, you will need: 1 cup rubbing alcohol, 1 cup water, 1 tablespoon dish soap, and a clean cloth. Combine the ingredients in a bowl and mix well. Dip the cloth into the mixture and wipe down your windshield. Rinse with clean water and dry. How Do You…

    Continue reading →

  • How to Read Harley Davidson Oil Dipstick?

    To read the Harley Davidson oil dipstick, first locate it on the left side of the engine. The dipstick will have a yellow or orange handle. Pull the dipstick out and wipe it off with a clean cloth. Reinsert the dipstick all the way and then pull it out again. The oil level should be…

    Continue reading →

  • How to Check Oil Pump Failure?

    The best way to check for oil pump failure is to take the car to a mechanic and have them do a diagnostic test. How Can You Tell If Your Oil Pump is Bad? If your oil pump is going bad, there are a few things you might notice. Your engine may make a whining…

    Continue reading →