An oil hedge trimmer is a tool that is used to trim hedges and shrubs. The oil hedge trimmer has a long, sharp blade that is attached to a handle. The user holds the handle in one hand and uses the other hand to guide the blade along the desired path. Can I Use Wd-40…
If you have an oil stain on your backpack, you can remove it by using a little dish soap and warm water. First, wet the area with the dish soap and water and then scrub it gently with a soft brush. Rinse the area well with warm water and then let it air dry. How…
The oil drain plug is typically located on the bottom of the engine, near the oil pan. In order to remove it, you will need a wrench that fits the size of the plug. Once you have located the plug, place the wrench on it and turn it counterclockwise until it is loose enough to…
Seafoam is an engine treatment that can be added to your oil or gas tank to clean and lubricate your engine. It is safe for all engines, including those with catalytic converters. To use seafoam in your oil, simply add it to your oil at the next oil change. For best results, add seafoam when…
An oil catch can is a device used to separate oil and other contaminants from the air being expelled by an internal combustion engine. The catch can trap these contaminants before they can enter into the engine’s intake system, where they could cause damage. Installing an oil catch can is a relatively simple process that…
The most common reason for an ATV to burn oil is because the piston rings are worn out. The piston rings seal the combustion chamber and prevent oil from getting into the cylinder. When the piston rings are worn out, oil can get past them and into the cylinder where it will be burned along…
Before checking the oil, the Yamaha Grizzly 660 should be turned off and given time to cool down. Once it is cooled, locate the dipstick on the left side of the engine near the front. The dipstick will have two marks that indicate the full and low levels of oil. Pull out the dipstick and…
To read your oil dipstick, remove it from the engine and wipe any oil off of it with a clean rag. Then, reinsert the dipstick into the engine and pull it out again. Look at the end of the dipstick that you just inserted into the engine—this is the “full” mark. Now, look at the…
To check the oil percentage in your Lexus RX 350, you will need to locate the dipstick on the engine. Once you have located the dipstick, pull it out and wipe it off with a clean cloth or paper towel. Next, insert the dipstick back into the engine and remove it again. The oil level…
If you’re worried that your coolant may be leaking into your oil, the best way to check is to take a sample of your oil and have it tested. Many auto parts stores offer this service for free. All you need is a clean, empty container and a few minutes of your time. Once you…