To change the oil on an inboard boat motor, you will need to locate the oil drain plug and unscrew it. Then, use a pump to remove the old oil from the reservoir. Once the old oil is removed, screw the drain plug back in and add new oil to the reservoir. Do Inboard Boat…
There are a few things you can do to test whether or not your 2 stroke oil pump is working. One is to check the oil level in the tank. If it’s low, then the pump isn’t working. Another way to tell is by starting up the engine and listening for a ticking sound. This…
Assuming you would like tips on how to drain your car’s oil: 1. Park your car on a level surface and wait until the engine is cool before beginning. 2. Find the oil drain plug underneath your car. It is typically located near the middle or back of the vehicle, close to where the oil…
If your engine is starting to sound a bit ‘off,’ it might be time for an oil change. But before you do that, you need to prime the engine with oil. This will ensure that all of the moving parts in your engine are properly lubricated and won’t cause any damage when they’re running. Here’s…
If your vehicle has an oil pump, it is important to know how to tell if it is bad. There are a few signs that may indicate your oil pump is going bad. The first sign is if your vehicle starts making a loud noise when you turn it on. This noise will usually be…
If your oil is foaming, it’s likely because it’s old or has been exposed to water. To stop the foaming, first try adding a drop or two of dish soap to the oil. If that doesn’t work, you can try heating the oil until the bubbles disappear. What Causes Oil to Foam Have you ever…
To change Harley oil, you will need: a new filter, fresh oil, a drain pan, and an adjustable wrench. First, remove the old filter and discard it. Next, use the wrench to loosen the drain plug at the bottom of the engine. Allow all of the oil to drain into the pan. Once finished draining,…
There are a few things you can do to remove excess oil from your car’s AC system. One is to simply let the system run for a while and allow the oil to evaporate. Another is to use a vacuum pump to suck out the oil. Finally, you can flush the system with a solvent…
If your car has an oil drain plug that uses a crush washer, you’ll need to replace the washer whenever you change your oil. Here’s how to do it: 1. Remove the old washer from the drain plug. 2. Place the new washer on the drain plug and screw it in by hand until it’s…
First, locate the oil dipstick on the outdrive. Next, remove the dipstick and wipe it clean with a rag. reinsert the dipstick all the way back in, then pull it out again to check the oil level. The oil should be at or above the “full” line on the dipstick. If it’s not, add more…