If you’re not sure whether your outboard’s oil injection system is working, there are a few things you can check. First, look for any obvious leaks in the system. If there are no leaks, then check the oil level in the reservoir. If the oil level is low, then topping it off may solve the…
To clean motor oil off of your engine, you will need a few supplies. You will need a pan or catch basin to catch the oil drippings, rags or paper towels, dish soap, and a hose with a spray nozzle attachment. First, place the pan under the engine where the oil is dripping. Second, use…
To prime an oil pump, first make sure that the pump is mounted securely and the suction line is properly installed. Next, fill the pump with oil and then turn on the power. Once the power is on, slowly open the discharge valve until you see a steady stream of oil coming out. If the…
To change the transmission oil on a Harley Softail, you will need to drain the old oil and then refill the transmission with new oil. You will need to do this every few thousand miles to keep your transmission in good working condition. How Much Transmission Oil Does a Harley Softail Hold? The Harley-Davidson Softail…
If your car has an oil leak coming from the head gasket, there are a few things you can do to try and fix it. First, you can try tightening the bolts that hold the head gasket in place. If that doesn’t work, you can try replacing the head gasket altogether. You’ll need to take…
To connect an oil catch can, first make sure that the can is securely mounted in a location where it will not get in the way of any moving parts. Then, use a hose to connect the outlet of the catch can to the drain port on your engine block. Finally, use another hose to…
To install an oil pressure gauge on a Chevy 350, first remove the oil sending unit from the engine block. Next, install the new oil pressure gauge in its place and screw it in tightly. Finally, reconnect the electrical connector to the sending unit and start the engine to check that the gauge is working…
First, identify the oil pan on your vehicle. It is typically a large, flat metal piece located near the bottom of the engine. Once you have located the oil pan, clean any dirt or debris off of it so that you can see what you are doing. Next, use a wrench to loosen the drain…
Removal of an old gasket from an oil pan can be a difficult and messy task. The first step is to remove all of the oil from the pan. This can be done by draining the oil or sucking it out with a vacuum pump. Once the oil is removed, the next step is to…
To change the oil in your lower unit, you’ll need to start by draining the old oil. To do this, remove the drain plug from the bottom of the lower unit and allow the oil to drain into a container. Once all of the old oil has been drained, replace the drain plug and fill…