Category: Blog

  • How to Remove Oil from Coolant System?

    If your car’s coolant system is contaminated with oil, it needs to be flushed to prevent damage to the engine. Here’s how to do it: 1. Park your car on a level surface and let it cool completely. Then, remove the radiator cap and add an equal amount of water and coolant flush solution to…

    Continue reading →

  • How to Add Oil to Mercury Outboard 2 Stroke?

    If your outboard is a two-stroke engine, it will require oil to be added to the fuel. The amount of oil that you need to add will depend on the size of your engine and the manufacturer’s recommendations. Most two-stroke engines will require you to mix the oil and fuel at a ratio of 50:1.…

    Continue reading →

  • How to Clean Oil off Your Engine?

    Assuming you would like tips on how to clean oil off your engine: 1. If the oil is fresh, use hot water and dish soap to break down the oil. Rinse with hot water. 2. For older stains, use a degreaser or all-purpose cleaner. Apply liberally and scrub with a brush until the stain lifts.…

    Continue reading →

  • How to Check Oil Level in Tank?

    Oil level in tank can be checked by using a dipstick. The dipstick is inserted into the oil tank and then withdrawn. The oil level is read from the markings on the dipstick. How Can I Measure How Much Oil is in My Tank? If you have an oil tank at home, it’s important to…

    Continue reading →

  • How to Tell If Your Oil Pump is Bad?

    If your car’s oil pressure light comes on, or you notice a drop in oil pressure while driving, it’s possible that your oil pump is failing. You may also hear strange noises coming from the engine area, especially when starting the car. These can be signs that the pump isn’t working properly and needs to…

    Continue reading →

  • How to Replace Camshaft Oil Seal

    1. Remove the timing belt cover and inspect the timing belt for wear. If the belt is worn, replace it with a new one. 2. Using a socket wrench, remove the crankshaft pulley bolt and then remove the pulley from the crankshaft. 3. Remove the camshaft sprocket bolts and then remove the sprocket from the…

    Continue reading →

  • How to Reset Oil Life on Honda Civic 2016

    To reset the oil life on a Honda Civic 2016, first turn the ignition key to the ON position without starting the engine. Then press and hold the Select/Reset button for about 10 seconds until the maintenance item light comes on. Release the button and then press it again for about 5 seconds until you…

    Continue reading →

  • How to Reset Honda Civic Oil Life

    To reset the oil life on a Honda Civic, start the engine and press the Select/Reset button on the dashboard. Scroll through the menu until you see “Oil Life” and press enter. The display will show 100% and then ask if you’d like to reset it. Press enter again to confirm. How Do You Reset…

    Continue reading →

  • How to Replace Oil Seal on Bush Hog

    Bush hogs, or rotary cutters, are used to clear land of brush and small trees. The oil seal on a bush hog helps keep the gearbox lubricated and prevents dirt and debris from entering. Over time, the oil seal can become worn out or damaged, causing leaks. When this happens, it’s necessary to replace the…

    Continue reading →

  • How to Delete Oil Injection on Mercury Outboard

    To remove the oil injection system from a Mercury outboard engine, first disconnect the oil line from the engine. Next, remove the oil pump and associated hardware. Finally, disconnect the wiring harness from the oil injection system and remove it from the engine. How Do You Bypass a 2 Stroke Oil Injection? Assuming you are…

    Continue reading →