To test your oil pressure gauge, you will need a few tools. A digital multimeter is the best tool to use, but you can also use an analog multimeter. You will also need a small screwdriver and a cloth. First, locate the oil pressure sending unit on your vehicle. It is usually located near the…
If your car has an oil cooler, you will need to install it before you can start using the car. Here is a step by step guide on how to install an oil cooler: 1. Find the location of the oil filter and unscrew it. 2. Remove the old oil cooler from its location. 3.…
If your car’s oil pressure is low at idle, there are a few things you can do to increase it. One is to add a higher viscosity oil, which will increase the pressure. Another is to change the oil pump, which will also increase the pressure. You can also try increasing the engine speed, which…
If you have a stripped oil drain plug, the first thing you need to do is remove the old oil. Once the old oil is removed, you will need to clean the area around the drain plug. Next, you will need to apply some lubricant to the threads of the drain plug. Finally, you will…
1. Before you begin, consult your vehicle’s owner’s manual to find the location of the oil pressure sending unit and identify the size and type of fitting required. 2. To install an oil pressure gauge, you will need a few tools including an oil pressure gauge kit, wrench set, screwdriver set, and pliers. 3. Most…
To add Lucas Oil Stabilizer, first find the oil fill cap on your engine. It is usually located on the top or side of the engine. Once you have found the oil fill cap, remove it and pour in the recommended amount of Lucas Oil Stabilizer. Then, replace the oil fill cap and start your…
If your oil pan plug is stripped, you’ll need to replace it. To do this, first remove the old plug using a wrench. Next, clean the area around the hole with a wire brush. Then, apply a thread sealant to the new plug and screw it in by hand. Finally, use a wrench to tighten…
If your oil drain plug is stripped, you will need to remove it in order to change the oil in your car. The best way to do this is with a pair of pliers. First, identify which direction the plug needs to be turned in order to be removed. Next, grip the plug with the…
If your Mazda oil light is on, it means that the oil level in your vehicle is low and needs to be refilled. To reset the light, simply add more oil to your car until the light goes off. How Do You Reset the Oil Light on a 2015 Mazda 3? If you need to…
1. Park your vehicle on a level surface and shut off the engine. Place a drip pan underneath the oil filter to catch any leaking oil. 2. Unscrew the oil filter with an oil filter wrench and let the old oil drain into the drip pan. Screw on a new oil filter, being careful not…