To reset the oil light on a Ford F150, first make sure that the vehicle is turned off. Next, open the hood and locate the oil dipstick. With the engine cool, remove the dipstick and wipe it clean with a rag.
Reinsert the dipstick all the way back into its tube, then remove it again to check your oil level. If the oil level is at or above the “full” mark on the dipstick, then your oil light should reset itself automatically. If it does not, you may need to consult your owner’s manual for further instructions.
- Park your Ford F150 in a level surface and turn off the engine
- Locate the oil dipstick on the side of the engine block
- Pull out the dipstick and wipe it with a clean cloth or paper towel
- Insert the dipstick all the way back in, then pull it out again to check the oil level
- If necessary, add more oil until it reaches between the “full” and “add” lines on the dipstick
- Replace the dipstick and screw on its cap, then start up your truck to see if the oil light has reset itself
How Do You Reset the Oil Light on a 2014 Ford F150?
Assuming you would like a step-by-step guide on how to reset the oil life monitor on your 2014 Ford F150:
1. Start the engine and allow it to run for a few minutes so that it is up to operating temperature.
2. Turn the engine off and locate the “Data Link Connector” (DLC).
This is usually found underneath the steering wheel near the brake pedal.
3. With the key in the “On” position, use a paperclip or small wire to jump pins 4 and 13 together inside the DLC. You should see either an “oil change required” message or something similar appear on your dash cluster display.
If nothing happens, check your manual to see if there are any additional steps required for your specific vehicle model year/type.
4. Once you see the message, release the wires and turn off your ignition key.
How Do You Reset the Oil Light on a 2010 Ford F150?
If your oil light is on, it means that your engine isn’t getting the proper amount of lubrication. You’ll want to reset the oil light as soon as possible to avoid any potential damage to your engine. Here’s how to do it:
1. Turn off your engine and allow it to cool for a few minutes.
2. Lift up the hood and locate the oil dipstick.
3. Remove the dipstick and wipe it clean with a rag or paper towel.
4. Reinsert the dipstick all the way back into its housing.
5. Pull the dipstick back out and check the oil level on the end of it. If it’s too low, add more oil until it reaches the “full” line on the dipstick.
How Do You Reset the Oil Light on a 2012 Ford F150?
Assuming you would like a step-by-step guide on resetting the oil light on your 2012 Ford F150:
1. Park your vehicle on level ground and turn off the engine.
2. Locate the oil dipstick under the hood of your car.
It will have a yellow or orange handle and will be inserted into the side of the engine block.
3. Pull out the dipstick and wipe it clean with a rag or paper towel. Reinsert it fully into the engine block and then pull it out again to check the oil level.
The oil should reach at least halfway up the dipstick, but no higher than the maximum line indicated. If it does not, add more oil until it reaches this level.
4. Find the button for your car’s trip odometer located on your dashboard near where the speedometer is located.
Press and hold this button until “Reset” appears in the display window above it. Then release the button and press it again until “Oil Life Reset” is displayed.
5..
Press and hold down this button once more for three seconds to reset your car’s oil life monitor back to 100%.
How Do You Reset the Oil Life on a 2016 Ford F150?
It is important to reset the oil life on your 2016 Ford f150 after each oil change. This can be done by following these simple steps:
1. Park your vehicle on a level surface and turn the engine off.
2. Locate the “Oil Life” button on your instrument panel. It is typically located near the odometer or speedometer.
3. Press and hold down the “Oil Life” button for three seconds until you see “Reset Oil Life 100%?” appear in the display window.
4. Press and release the “Set/Reset” button to confirm that you want to reset the oil life back to 100%. The display should now show “OIL LIFE RESET 100%”.
2018-2019 Ford F-150 Oil life reset procedure
Ford Oil Life Reset
If you own a Ford vehicle, then at some point you will need to reset the oil life indicator. This is a maintenance reminder that lets you know when it’s time to change your oil. Luckily, it’s a pretty simple process that only takes a few minutes to do.
First, start the engine and let it run for a minute or two. Then turn it off and locate the oil life reset button. It should be located on the instrument panel, near the speedometer or tachometer.
Press and hold this button for about 10 seconds until the indicator light starts flashing. Once it does, release the button and your oil life has been reset!
It’s important to note that you should only reset the indicator when you’ve actually changed your oil.
Otherwise, you won’t be getting accurate information about when your next oil change is due. So don’t forget to schedule an appointment with your local Ford dealer or service center as soon as possible after completing this procedure.
2002 Ford F150 Oil Light Reset
If the oil light on your 2002 Ford F150 is illuminated, it means that the engine is low on oil. You will need to add oil to the engine to bring the level back up to normal. To reset the oil light, simply add oil to the engine until the light goes off.
Ford F150 Oil Change Required
The Ford F-150 is a truck that’s known for its durability and off-road capabilities. But like any vehicle, it requires regular maintenance to keep it running smoothly. One of the most important maintenance tasks you can do for your F-150 is to change its oil regularly.
Most mechanics recommend changing the oil in a Ford F-150 every 5,000 miles or so. However, this may vary depending on how often you use your truck and what kind of driving you do (stop-and-go city driving vs. highway driving). It’s always best to consult your owner’s manual or a qualified mechanic to find out what interval is best for your truck.
Changing the oil in a Ford F-150 is relatively simple and can be done in about 30 minutes. All you need is a new filter and some fresh oil (check your owner’s manual to find out what type of oil is recommended). Once you have these supplies, just follow these steps:
1) Park your truck on level ground and engage the parking brake. 2) Place a drain pan beneath the engine where the oil will drain out. 3) Locate the oil drain plug at the bottom of the engine (it will have an O-ring seal around it).
4) Remove the drain plug with a wrench and let all of the old oil drain into the pan. 5) Clean off the old gasket from both sides ofthe drain plug and apply some fresh grease tothe new gasket before screwing it back into place 6) Find the oil filter housing (usually located nearthe front ofthe engine block onthe driver’s side).
7) Unscrewthe housing cap witha wrenchand removethe oldfilter 8) Installa newfilter byscrewingit intothe housing until it’s snug 9) Put freshoil intotheengine – again, checkyour ownersmanualto seewhat typeand howmuchis needed 10 Fill uptho about3/4ofway betweenthe minimumand maximummarksonthe dipstick 11 Startupthe engineto makethe newoilcirculatebeforecheckingforleaks 12 Checkfor leaksbylookingaroundthesedanplugsand thafilterhousing 13 Shutoffengine 14 Recycleyour usedoilat anauthorizedcollectionpoint – don’t pourit downStormdrainsor throwit inGarbage!
2013 Ford F150 Oil Change Reset
If you own a 2013 Ford F150, then you know that it’s important to keep up with your vehicle’s maintenance. This includes changing the oil regularly. But sometimes, it can be easy to forget when your last oil change was.
That’s where the oil change reset comes in handy.
The oil change reset is a feature on your Ford F150 that keeps track of when your last oil change was. It’s located in the instrument cluster, and it will let you know when it’s time for another oil change.
To reset the indicator, simply press and hold the trip odometer button for about five seconds. The indicator will then go back to zero, and you’ll have a fresh start on tracking your next oil change.
Keeping up with regular maintenance is important for any vehicle, but it’s especially important for a truck like the Ford F150.
So if you’re unsure of when your last oil change was, make sure to check the oil change reset and get yourself back on track!
Conclusion
If you’re looking to reset your oil light on your Ford F150, there are a few things you’ll need to do. First, find the oil dipstick and remove it from the engine. Next, wipe off the dipstick and reinsert it into the engine.
Once it’s all the way in, pull it out and check the level of oil on the stick. If it’s at or above the full line, then your oil light should reset itself automatically.
Leave a Reply