Author: Michael John
-
How to Check Oil in Prius?
There are two ways to check the oil in your Prius. The first is to use the dipstick. The second is to check the oil level indicator on the multi-information display. How Do I Know If My Prius is Low on Oil? If you own a Prius, it’s important to be aware of how to…
-
How to Clean Old Oil off Concrete?
To remove old oil stains from concrete, first mix a solution of 1 part dish soap to 3 parts warm water. Next, using a stiff brush, scrub the stain vigorously. If the stain is still visible, you can try using a pressure washer with detergent to remove it. Does Dawn Dish Soap Remove Oil from…
-
How to Oil Hedge Trimmer?
An oil hedge trimmer is a tool that is used to trim hedges and shrubs. The oil hedge trimmer has a long, sharp blade that is attached to a handle. The user holds the handle in one hand and uses the other hand to guide the blade along the desired path. Can I Use Wd-40…
-
How to Remove Oil Stains from Backpacks?
If you have an oil stain on your backpack, you can remove it by using a little dish soap and warm water. First, wet the area with the dish soap and water and then scrub it gently with a soft brush. Rinse the area well with warm water and then let it air dry. How…
-
How to Loose Oil Drain Plug?
The oil drain plug is typically located on the bottom of the engine, near the oil pan. In order to remove it, you will need a wrench that fits the size of the plug. Once you have located the plug, place the wrench on it and turn it counterclockwise until it is loose enough to…
-
How to Use Seafoam in Oil?
Seafoam is an engine treatment that can be added to your oil or gas tank to clean and lubricate your engine. It is safe for all engines, including those with catalytic converters. To use seafoam in your oil, simply add it to your oil at the next oil change. For best results, add seafoam when…
-
How to Install Oil Catch Can?
An oil catch can is a device used to separate oil and other contaminants from the air being expelled by an internal combustion engine. The catch can trap these contaminants before they can enter into the engine’s intake system, where they could cause damage. Installing an oil catch can is a relatively simple process that…
-
How to Stop Atv from Burning Oil?
The most common reason for an ATV to burn oil is because the piston rings are worn out. The piston rings seal the combustion chamber and prevent oil from getting into the cylinder. When the piston rings are worn out, oil can get past them and into the cylinder where it will be burned along…
-
How to Check Oil on Yamaha Grizzly 660?
Before checking the oil, the Yamaha Grizzly 660 should be turned off and given time to cool down. Once it is cooled, locate the dipstick on the left side of the engine near the front. The dipstick will have two marks that indicate the full and low levels of oil. Pull out the dipstick and…
-
How to Read Oil Dipstick With 2 Holes
To read your oil dipstick, remove it from the engine and wipe any oil off of it with a clean rag. Then, reinsert the dipstick into the engine and pull it out again. Look at the end of the dipstick that you just inserted into the engine—this is the “full” mark. Now, look at the…