Author: Michael John
-
How to Reset Mazda Oil Light?
If your Mazda oil light is on, it means that the oil level in your vehicle is low and needs to be refilled. To reset the light, simply add more oil to your car until the light goes off. How Do You Reset the Oil Light on a 2015 Mazda 3? If you need to…
-
How to Install Oil Pressure Gauge?
1. Park your vehicle on a level surface and shut off the engine. Place a drip pan underneath the oil filter to catch any leaking oil. 2. Unscrew the oil filter with an oil filter wrench and let the old oil drain into the drip pan. Screw on a new oil filter, being careful not…
-
How to Align Oil Pump Shaft With Distributor?
The oil pump shaft must be aligned with the distributor before the engine can be started. There are two ways to do this: 1. With the engine at TDC (top dead center), remove the distributor cap and look at the rotor. The rotor should be pointing to the #1 cylinder on the distributor cap. If…
-
How to Remove Oil from Brake Pads?
There are a few ways that you can remove oil from your brake pads. One way is to use a paper towel or cloth to wipe the excess oil off of the pad. Another way is to use a brake cleaner spray. You can also remove the pads and clean them with soap and water.…
-
How to Check Oil on a Harley Davidson Motorcycle?
The process for checking the oil on a Harley Davidson motorcycle is as follows: 1. Park the motorcycle on a level surface and turn it off. 2. Place a clean, dry rag over the end of the dipstick (located under the seat) and pull it out. 3. Wipe any oil off of the dipstick with…
-
How to Repair Oil Pump?
If your car’s oil pump needs to be repaired, there are a few things you can do to fix it. First, check the oil level and add more if necessary. Next, check the oil filter and clean or replace it if needed. Finally, check the oil pump itself for any damage or debris that may…
-
How to Remove Stripped Thread Oil Drain Plug?
If your oil drain plug gets stripped, don’t worry. There are a few easy ways to remove it. One way is to use a pair of pliers. Just grip the plug tightly and turn it counterclockwise. If the plug is really tight, you may need to use a wrench or socket to get it started.…
-
How to Get Oil off Brake Pads?
If your brake pads have become contaminated with oil, there are a few steps you can take to clean them. First, try wiping the pads down with a rag soaked in mineral spirits. If that doesn’t work, you can remove the pads and soak them in a solution of water and dish soap for several…
-
How to Remove Broken Oil Dipstick Tube?
1. Remove the oil dipstick and its tube. 2. Using a pair of pliers, grip the end of the broken tube that’s still in the engine and pull it out. 3. Clean off any oil and debris from around the hole where the dipstick tube was located. 4. Install a new oil dipstick tube by…
-
How to Get Water Out of Atv Oil?
To get water out of ATV oil, you will need to use a water separator. This is a device that will remove the water from the oil by using centrifugal force. How Do You Get Water Out of Engine Oil? If you find water in your engine oil, it’s important to get it out as…